General description
A special aluminum motor yacht designed by Bes Yacht Design and built for the current (first) owner. His wish was a sturdy, comfortable and well-built yacht, a round bilge with flared bow for the smaller and larger waters. Wide side decks, 4 + 2 berths, bow thruster, anchor winch, long integrated swimming ladder, spacious open cockpit with teak on cockpit benches and floor. Bow ladder for easy on and off the boat. Mahogany interior paneling with two single sleeping cabins and a double front cabin. Spacious kitchen and dinette (convertible to bed), comfortable Tayler stove, shower with toilet. Salon with large sliding hatch, chart table and steering position. The hull and superstructure are 5 mm thick aluminum built and has an Awlgrip paint system. The surface is 6 mm thick aluminum. Around is a large rubber bumper present. In the aluminum mast you can hoist a pendulum sail and the mast is easy to strike. To be viewed at wehmeyer in Naarden.
General
with range stem
Hull and superstructure are built of 5 mm thick aluminum and the plane is 6 mm thick. Paint system is from Awlgrip.
Accommodation
Isotemp
Manual
Philips
(petroleum)
220V.
(with compressor)
stove
Taylor (petroleum)
Engine, electrics
The propeller has ;a special shape (endplate propeller) saves about 300 rvm at the same speed.
12V 220V
Navigation and electronics
Rig and sails
(for pendulum sail)
Roof hatch and mast are plastic (light weight). Support sail is never used
Deck Equipment
Simpson
stainless steel
partially integrated
teak on cockpit floor and on cockpit benches.
Safety
Electric